Bearing Replacement

To remove the bearings heat to the parts 250 F and drive out bearings. Usually you can just knock the parts against a wood bench and the bearing will fall out.

To install bearings, heat aluminum parts to the parts 325 F and drive in bearings. Make sure that bearings are seated and that single sided seals are correctly installed. The following table is for Narrow Case motors.

Engine Bearings Qty Bearing Number Seal Special Main Bearings 2 6206 No Cam Shaft 2 6202 No Upper Tower Shaft 1 1202 No Bevel Gear 2 7202B No Steel Cage Main Shaft Chain Side 1 6204 2RS Remove one seal Lay Shaft Clutch Side 1 6204 No Lay Shaft Chain Side 1 6203 2RS Remove one seal Outer Crank Shaft 1 6203 No Clutch Housing 2 16004 No