Flywheel puller.

[ERIC SUMMERS]

I need to pull the flywheel on my Moto Morini 3&1/2 In order to change the cam drive belt.The threads required are M 27-1.25 .Can any one tell me where I can purchase or borrow a puller of this size.
TNXS. Eric.

[darnold]

Is that internal or external M27 on the flywheel? If it's internal it's easy to turn that external thread on a lathe, make a puller.

-dan

[ERIC SUMMERS]

Hello Dan.
It's an internal thread on the flywheel.I can buy one in England for eight pounds plus shipping and handling. Hendan in Pennsylvania are out of stock. when I took a drawing of the puller to my local machine shop he quoted me 2 hours at $80.00.Apparently it is the same puller as a Lambretta.Dan ,what is the thread size for a Ducati single?
TNXS. Eric.

[darnold]

I think there are three different sizes on the singles but they are all external threads.

-dan

[Jack C]

Eric,

Does the supplier in England have pullers for ducati narrow case models at that same, great price? I see them on ebay for $60-$130.

I would appreciate any info you have.

Jack

[BevHevSteve]

There are 2 different size pullers for all ducati singles, either 55mm or 62mm. Just pull the primary side cover off, look down between the primary gear and the magneto. You can eyeball the distance using a straightedge or ruler.

I stock the pullers ar $102.75 each - all the ducati tools are posted below

[ERIC SUMMERS]

Hello all.

Thanks for your advice, i discovered that the Moto Morini flywheel is the same size as a K.T.M.

TNXS. Eric.