Swingarm Bearings Replacement '93 900SS
2 posts
• Page 1 of 1
Swingarm Bearings Replacement '93 900SS
Does anyone have any experience changing the swingarm Needle bearings pressfit into the cases for a 900 DesmoDue. The retaining clip doesn't allow much clearance for a blind puller to get a decent amount of metal pushing against the bearing. Any Tips?
Thanks,
Steve
Thanks,
Steve
- Steve302
- Posts: 7
- Joined: Thu Oct 05, 2006 2:22 pm
- Location: Ancaster, Ontario
Re: Swingarm Bearings Replacement '93 900SS
Assumming you are not going to reuse the bearings, the easiest approach is a long thin drift. Remove the outboard seals first and drive the bearings and inner seals out from the opposite side catching whatever edge you can with the drift. They pop out easily. Replacement is straight forward provided the circlips are still in place. You can get replacement bearings and seals from any decent bearing house.
- jon snadden
- Posts: 27
- Joined: Sun Feb 27, 2005 7:41 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 25 guests