WTB Ducati Bevel Twin Intake Manifolds ( 40 mm Carbs )
4 posts
• Page 1 of 1
WTB Ducati Bevel Twin Intake Manifolds ( 40 mm Carbs )
Good Day:
I am looking for a set of intake manifolds for a race bike project. I believe early 900SS ( 1975 to ? ), prior to when they curved the rear one to clear the battery, are the ones I need. From what I remember the rear manifold came pretty much straight out with a slight upwards kink. Carbs are 40 mm spigot mount with 58mm bolt spacing. Any information would be appreciated. Thank you for your time.
Regards
I am looking for a set of intake manifolds for a race bike project. I believe early 900SS ( 1975 to ? ), prior to when they curved the rear one to clear the battery, are the ones I need. From what I remember the rear manifold came pretty much straight out with a slight upwards kink. Carbs are 40 mm spigot mount with 58mm bolt spacing. Any information would be appreciated. Thank you for your time.
Regards
- Lou Zeman
- Posts: 4
- Joined: Mon Nov 23, 2009 1:15 pm
Re: WTB Ducati Bevel Twin Intake Manifolds ( 40 mm Carbs )
In the past I purchased the manifold's your are looking from Syd's Cycle in Florida. Syd and Malcom (son) are fax and phone only I am afraid.
You can also try Bevelheaven, they may have what you are looking for.
Vendor 'motocorseducati' has these cool red anodised ones on eBay.
Those are the places I would start with.
Good Luck.
Rob
You can also try Bevelheaven, they may have what you are looking for.
Vendor 'motocorseducati' has these cool red anodised ones on eBay.
Those are the places I would start with.
Good Luck.
Rob
Rob Marshall - '95 Ducati 900SS
- '85 Cagiva 650 Allazurra
- '85 Cagiva 650 Allazurra
- ducati588
- Posts: 74
- Joined: Tue Dec 20, 2005 11:32 am
- Location: Richmond, Ontario
Re: WTB Ducati Bevel Twin Intake Manifolds ( 40 mm Carbs )
You can also try Road and Race in Australia. Phil Hitchcock is one of the good ones.
Dave G
Dave G
Dave Gooch
aka The Goochman
aka The Goochman
- The Goochman
- Posts: 746
- Joined: Fri Jan 14, 2005 10:24 pm
- Location: Sarnia ON
Re: WTB Ducati Bevel Twin Intake Manifolds ( 40 mm Carbs )
Thank you for your help and for the contacts.
- Lou Zeman
- Posts: 4
- Joined: Mon Nov 23, 2009 1:15 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests